
- Description
- Downloads
Pole Shaft:
The pole shall be a one section design conforming to ASTM A595 Grade A or ASTM A572 Grade 55 with a constant taper rate of .14 in/ft. Pole will be cylindrical in cross-section and will have a full length longitudinal weld.
Base Plate:
The base plate is fabricated from a structural quality hot rolles carbon steel plate that meets or exceeds ASTM A-36 with a minimum yield strength of 36,000 psi. The base plate telescopes the pole shaft and is circumferential welded top and bottom.
Base Cover:
The two-piece standard full base cover is fabricated from ABS plastic. Optional two-piece steel base cover also available.
Anchor Bolts:
Anchor bolts conform to ASTM F1554 Grade 55 and are provided with two hex nuts and flat washers. Bolts have an “L” bend on one end and are galvanized a minimum of 12” on the threaded end in accordance with ASTM A-153.
Handhole:
A reinforced hand hole, having a nominal opening of 3”x 5” or 4” x 6.5” will be installed 18” above the base plate. A hand hole cover with hardware will be included along with grounding provisions.
Pole Top:
Each pole will be provided with a welded top plate and tenon or top cap for poles receiving drilling for side mount fixtures.
Finish:
Standard color finishes shall be coated with TGIC polyester powder or hot dip galvanized to ASTM A-123 specifications.